CREATIVE CT6670 DRIVER

0 Comments

Leave a Reply Cancel reply Your email address will not be published. April 21, at 5: What equipment can you get your hand on? Easiest technique is big tip loaded with a blob of solder — soak whole component and lift, bang on a desk to remove. Proudly powered by WordPress.

Uploader: Malakree
Date Added: 1 June 2016
File Size: 6.34 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 2490
Price: Free* [*Free Regsitration Required]

Min reset time when clock is running is uS.

April cct6670, at 9: A soft reset holds the reset signal for a very short time and consistently ends up with the wrong PCI device ID. April 14, at 3: April 17, at 6: April 15, at Thanks for the finger test tip. Your email address will not be published.

The same behavior occurs in DOS and Windows I looked at the pictures of this and all other 3dfx cards at http: Obviously that is some weird voodoo. Thanks for the hints.

Hardware museum

The Creative Voodoo 2 boards were also the first, and mine are the old revision. P have much simpler pcbs and reset clearly cteative to inverter, its like they forgot PCI reset signal is inverted during asic development?.

  ALERT POPUP IN SELENIUM WEBDRIVER DRIVER DOWNLOAD

No idea if that might have any bearing on the reset behavior. April 5, at 8: April 13, at 1: And if you have to remove it then yeah, might as well replace it with a known good one.

CREATIVE 3dfx Voodoo 2 CT6670

If I press it short or longer reset works fine. Loss of capacity, rising ESR, dead shorts or hairline cracks.

Easiest technique is big tip loaded with a blob of solder — soak whole component and lift, bang on a desk to remove. I remember removing them in early nineties from cheap S3 cards to bump picture quality at high resolutions when x was high. I dont suspect shorts on bypassing caps, those cy6670 end in hardware not powering up or burn marks: One of them probably connects to pin 10 or pin Vishay SMD ferrite beads http: Creatve is that possible?

April 5, at Based on contemporary literature, the Creative Voodoo 2 was unmodified 3Dfx reference design. Fine tips have bad thermal capacity, and I dont expect you to have decent soldering gear. If you push very fast you and ct66670 with my board get one reset pulse, too short.

  INTEL R ICH9 6 PORT SATA AHCI CONTROLLER 2922 DRIVER

Voodoo 2 Creative CT for sale

This leaves the card as a main suspect. Check it with multimeter to be sure. April 6, at 1: I also have some flat soldering tips which could be better for this? If the reset button is just lightly touched, the behavior is the same as with soft reset.